What type of natural selection favors individuals with both extreme traits?
|
Natural selection can take many forms. To make talking about this easier, we will consider the distribution of traits across a population in graphical form. In we see the normal bell curve of trait distribution. For example, if we were talking about height as a trait, we would see that without any selection pressure on this trait, the heights of individuals in a population would vary, with most individuals being of an average height and fewer being extremely short or extremely tall. However, when selection pressures act on a trait, this distribution can be altered. Show
Stabilizing selectionWhen selective pressures select against the two extremes of a trait, the population experiences stabilizing selection. For example, plant height might be acted on by stabilizing selection. A plant that is too short may not be able to compete with other plants for sunlight. However, extremely tall plants may be more susceptible to wind damage. Combined, these two selection pressures select to maintain plants of medium height. The number of plants of medium height will increase while the numbers of short and tall plants will decrease. Directional selectionIn directional selection, one extreme of the trait distribution experiences selection against it. The result is that the population's trait distribution shifts toward the other extreme. In the case of such selection, the mean of the population graph shifts. Using the familiar example of giraffe necks, there was a selection pressure against short necks, since individuals with short necks could not reach as many leaves on which to feed. As a result, the distribution of neck length shifted to favor individuals with long necks. Disruptive SelectionIn disruptive selection, selection pressures act against individuals in the middle of the trait distribution. The result is a bimodal, or two-peaked, curve in which the two extremes of the curve create their own smaller curves. For example, imagine a plant of extremely variable height that is pollinated by three different pollinators, one that was attracted to short plants, another that preferred plants of medium height and a third that visited only the tallest plants. If the pollinator that preferred plants of medium height disappeared from an area, medium height plants would be selected against and the population would tend toward both short and tall, but not medium height plants. Such a population, in which multiple distinct forms or morphs exist is said to be polymorphic. Stabilizing selection is often noticeable after artificial selection. Breeders choose chickens that produce larger eggs, cows that yield more milk, and corn with higher protein content. But the selection must be continued or reinstated from time to time, even after the desired goals have been achieved. If it is stopped altogether, natural selection gradually takes effect and turns the traits back toward their original intermediate value. As a result of stabilizing selection, populations often maintain a steady genetic constitution with respect to many traits. This attribute of populations is called genetic homeostasis. Directional selectionThe distribution of phenotypes in a population sometimes changes systematically in a particular direction. (See the centre column of the figure.) The physical and biological aspects of the environment are continuously changing, and over long periods of time the changes may be substantial. The climate and even the configuration of the land or waters vary incessantly. Changes also take place in the biotic conditions—that is, in the other organisms present, whether predators, prey, parasites, or competitors. Genetic changes occur as a consequence, because the genotypic fitnesses may shift so that different sets of alleles are favoured. The opportunity for directional selection also arises when organisms colonize new environments where the conditions are different from those of their original habitat. In addition, the appearance of a new favourable allele or a new genetic combination may prompt directional changes as the new genetic constitution replaces the preexisting one. The process of directional selection takes place in spurts. The replacement of one genetic constitution with another changes the genotypic fitnesses at other loci, which then change in their allelic frequencies, thereby stimulating additional changes, and so on in a cascade of consequences. Directional selection is possible only if there is genetic variation with respect to the phenotypic traits under selection. Natural populations contain large stores of genetic variation, and these are continuously replenished by additional new variants that arise by mutation. The nearly universal success of artificial selection and the rapid response of natural populations to new environmental challenges are evidence that existing variation provides the necessary materials for directional selection. In modern times human actions have been an important stimulus to this type of selection. Human activity transforms the environments of many organisms, which rapidly respond to the new environmental challenges through directional selection. Well-known instances are the many cases of insect resistance to pesticides, which are synthetic substances not present in the natural environment. When a new insecticide is first applied to control a pest, the results are encouraging because a small amount of the insecticide is sufficient to bring the pest organism under control. As time passes, however, the amount required to achieve a certain level of control must be increased again and again until finally it becomes ineffective or economically impractical. This occurs because organisms become resistant to the pesticide through directional selection. The resistance of the housefly, Musca domestica, to DDT was first reported in 1947. Resistance to one or more pesticides has since been recorded in several hundred species of insects and mites. Another example is the phenomenon of industrial melanism (mentioned above in the section Gene mutations), which is exemplified by the gradual darkening of the wings of many species of moths and butterflies living in woodlands darkened by industrial pollution. The best-investigated case is the peppered moth, Biston betularia, of England. Until the middle of the 19th century, these moths were uniformly peppered light gray. Darkly pigmented variants were detected first in 1848 in Manchester and shortly afterward in other industrial regions where the vegetation was blackened by soot and other pollutants. By the middle of the 20th century, the dark varieties had almost completely replaced the lightly pigmented forms in many polluted areas, while in unpolluted regions light moths continued to be the most common. The shift from light to dark moths was an example of directional selection brought about by bird predators. On lichen-covered tree trunks, the light-gray moths are well camouflaged, whereas the dark ones are conspicuously visible and therefore fall victim to the birds. The opposite is the case on trees darkened by pollution. Over geologic time, directional selection leads to major changes in morphology and ways of life. Evolutionary changes that persist in a more or less continuous fashion over long periods of time are known as evolutionary trends. Directional evolutionary changes increased the cranial capacity of the human lineage from the small brain of Australopithecus—human ancestors of three million years ago—which was less than 500 cc in volume, to a brain nearly three times as large in modern humans. The evolution of the horse from more than 50 million years ago to modern times is another well-studied example of directional selection. Diversifying selectionTwo or more divergent phenotypes in an environment may be favoured simultaneously by diversifying selection. (See the right column of the figure.) No natural environment is homogeneous; rather, the environment of any plant or animal population is a mosaic consisting of more or less dissimilar subenvironments. There is heterogeneity with respect to climate, food resources, and living space. Also, the heterogeneity may be temporal, with change occurring over time, as well as spatial. Species cope with environmental heterogeneity in diverse ways. One strategy is genetic monomorphism, the selection of a generalist genotype that is well adapted to all the subenvironments encountered by the species. Another strategy is genetic polymorphism, the selection of a diversified gene pool that yields different genotypes, each adapted to a specific subenvironment. There is no single plan that prevails in nature. Sometimes the most efficient strategy is genetic monomorphism to confront temporal heterogeneity but polymorphism to confront spatial heterogeneity. If the environment changes in time or if it is unstable relative to the life span of the organisms, each individual will have to face diverse environments appearing one after the other. A series of genotypes, each well adapted to one or another of the conditions that prevail at various times, will not succeed very well, because each organism will fare well at one period of its life but not at others. A better strategy is to have a population with one or a few genotypes that survive well in all the successive environments. If the environment changes from place to place, the situation is likely to be different. Although a single genotype, well adapted to the various environmental patches, is a possible strategy, a variety of genotypes, with some individuals optimally adapted to each subenvironment, might fare still better. The ability of the population to exploit the environmental patchiness is thereby increased. Diversifying selection refers to the situation in which natural selection favours different genotypes in different subenvironments. The efficiency of diversifying natural selection is quite apparent in circumstances in which populations living a short distance apart have become genetically differentiated. In one example, populations of bent grass can be found growing on heaps of mining refuse heavily contaminated with metals such as lead and copper. The soil has become so contaminated that it is toxic to most plants, but the dense stands of bent grass growing over these refuse heaps have been shown to possess genes that make them resistant to high concentrations of lead and copper. But only a few metres from the contaminated soil can be found bent grass plants that are not resistant to these metals. Bent grasses reproduce primarily by cross-pollination, so that the resistant grass receives wind-borne pollen from the neighbouring nonresistant plants. Yet they maintain their genetic differentiation because nonresistant seedlings are unable to grow in the contaminated soil and, in nearby uncontaminated soil, the nonresistant seedlings outgrow the resistant ones. The evolution of these resistant strains has taken place in the fewer than 400 years since the mines were first opened. Protective morphologies and protective coloration exist in many animals as a defense against predators or as a cover against prey. Sometimes an organism mimics the appearance of a different one for protection. Diversifying selection often occurs in association with mimicry. A species of swallowtail butterfly, Papilio dardanus, is endemic in tropical and Southern Africa. Males have yellow and black wings, with characteristic tails in the second pair of wings. But females in many localities are conspicuously different from males; their wings lack tails and have colour patterns that vary from place to place. The explanation for these differences stems from the fact that P. dardanus can be eaten safely by birds. Many other butterfly species are noxious to birds, and so they are carefully avoided as food. In localities where P. dardanus coexists with noxious butterfly species, the P. dardanus females have evolved an appearance that mimics the noxious species. Birds confuse the mimics with their models and do not prey on them. In different localities the females mimic different species; in some areas two or even three different female forms exist, each mimicking different noxious species. Diversifying selection has resulted in different phenotypes of P. dardanus as a protection from bird predators. What type of natural selection favors both extremes?Disruptive or Diversifying selection
occurs when natural selection favors both extremes of continuous variation.
In which type of natural selection individuals with both extremes of traits are rejected?Disruptive Selection☆
Disruptive selection occurs when individuals of intermediate phenotype are less fit than those of both higher and lower phenotype, such that extremes are favored. This may occur if there are two diverse food sources or predators with diverse preferences for, say, size of prey.
Which type of natural selection favors the evolution of both phenotypic extremes in a trait?Disruptive selection favors both extreme phenotypes, different from one extreme in directional selection. Stabilizing selection favors the middle phenotype, causing the decline in variation in a population over time.
What type of selection are both extremes selected for?Disruptive Selection
This type of natural selection occurs when selective pressures are working in favour of the two extremes and against the intermediate trait.
|
