Lỗi microstation cannot measure area of this element
|
For curves, sets the maximum percentage of the distance between the true curve and the approximation used to measure. A low Tolerance makes the measurement more accurate but increases calculation time. Show Mass Properties If on, the mass property analysis is displayed in the . Display Centroid If on, a graphic crosshair that represents the measured element's center of mass is displayed. Locate Interior Shapes (When Method is set to Flood) Sets the largest distance allowed between consecutive elements. If zero, the elements must connect to bound an area. Applies To Product(s): MicroStation Version(s): 08.09.03.57 Environment: N\A Area: Measure Subarea: N\A Original Author: Bentley Technical Support Group ProblemMeasure Area tool does not start and tool settings do not show. Product: MicroStation V8 XM Edition Version: 08.09.03.57 Area: Dimension/Measure, PROBLEMSOLVING SolutionPlace a fence in the view, the start the tool. Reason: Measure Area tool has Method set to "Fence" but no fence is placed. When the tool was last used it was used with a fence and the Method set to "Fence", but then the fence was clear afterwards. The Prompt and Message Center reports message "No Fence Defined". To correct: 1. Place a fence somewhere in the view, then start Measure Area. [The tool should now start] 2. Switch the Method to the desired setting. 3. Use tool as needed. Notes: In MicroStation V8 XM edition 08.09.03.57 and previous, the Prompt does not keep the warning visible but it is still listed in the Message Center. Starting with MicroStation V8 XM Edition version 08.09.04.24 the Prompt area retains the warning message. I use this tool often, and now it appears to not be working on some elements. Is anyone else having this problem? I select the tool and select my starting point. The element will highlight, but there's no dynamic highlight to go with that. When finished, it queries me for the next point, but there is no result. Sometimes the elements are in a reference file, sometimes they are in the active file. Sometimes I can measure one reference file but not another (settings are all the same). Sometimes I can measure in View 2, but not View 1. All the files are 2D. Very frustrating. That may not be enough to go on...but it's what I've got. MaryB MSTN 08.11.09.292
Bhavesh, I have had this issue off and on for quite a while. I was going to attach the file that I am having the issue now but I do not know how to do that. I work in CADD Support for MaineDOT and this is an issue for us since a lot of us use this tool. I just started in this position so I am learning as I am going. Here is my summary of my issue. I have had issues with using the Measure Distance Along Element tool where it will not select the curve (element) and highlight it so it will measure along it. The most recent occurrence is along a 5,770 ft. curve on an alignment. I want to measure from a Station mark to another line intersecting the curve. I select the start point then reject the section of the Station mark and then accept the selection of the Alignment line. Then it just highlights part of the Station mark and gives me its distance. This is something that happens quite often and it seems to be on curves and ones along a string or SmartLine. Any suggestions are welcomed. We are using MicroStation V8i SS2 v. 08.11.07.443 |
